Marine piling - energy conversion factors in underwater radiated sound: review

A report which investigates the Energy Conversion Factor (ECF) method and provides recommendations regarding the modelling approaches for impact piling as used in environmental impact assessments (EIA) in Scottish Waters.


Glossary

Unless otherwise stated in an entry, these definitions are consistent with ISO 18405 (2017).

1/3‑octave

One third of an octave. Note: A 1/3-octave is approximately equal to one decidecade (1/3 oct ≈ 1.003 ddec).

1/3‑octave‑band

Frequency band whose bandwidth is one 1/3‑octave. Note: The bandwidth of a 1/3-octave‑band increases with increasing centre frequency.

absorption

The conversion of sound energy to heat energy. Specifically, the reduction of sound pressure amplitude due to particle motion energy converting to heat in the propagation medium.

acoustic impedance

The ratio of the sound pressure in a medium to the volume flow rate of the medium through a specified surface due to the sound wave. It is a measure of how well sound propagates through a particular medium.

attenuation

The gradual loss of acoustic energy from absorption and scattering as sound propagates through a medium. Attenuation depends on frequency—higher frequency sounds are attenuated faster than lower frequency sounds.

auditory frequency weighting

The process of applying an auditory frequency-weighting function. An example for marine mammals are the auditory frequency-weighting functions published by Southall et al. (2007).

auditory frequency-weighting function

Frequency-weighting function describing a compensatory approach accounting for a species’ (or functional hearing group’s) frequency-specific hearing sensitivity.

azimuth

A horizontal angle relative to a reference direction, which is often magnetic north or the direction of travel. In navigation it is also known as bearing.

bandwidth

A range within a continuous band of frequencies. Unit: hertz (Hz).

broadband level

The total level measured over a specified frequency range. If the frequency range is unspecified, the term refers to the entire measured frequency range.

compressional wave

A mechanical vibration wave in which the direction of particle motion is parallel to the direction of propagation. Also called a longitudinal wave. In seismology/geophysics, it’s called a primary wave or P-wave. Shear waves in the seabed can be converted to compressional waves in water at the water-seabed interface.

decade

Logarithmic frequency interval whose upper bound is ten times larger than its lower bound (ISO 80000-3:2006). For example, one decade up from 1000 Hz is 10,000 Hz, and one decade down is 100 Hz.

decibel (dB)

Unit of level used to express the ratio of one value of a power quantity to another on a logarithmic scale. Especially suited to quantify variables with a large dynamic range.

decidecade

One tenth of a decade. Approximately equal to one third of an octave (1 ddec ≈ 0.3322 oct), and for this reason sometimes referred to as a 1/3‑octave.

decidecade band

Frequency band whose bandwidth is one decidecade. Note: The bandwidth of a decidecade band increases with increasing centre frequency.

energy source level

A property of a sound source equal to the sound exposure level measured in the far field plus the propagation loss from the acoustic centre of the source to the receiver position. Unit: decibel (dB). Reference value: 1 μPa2 m2 s.

ensonified

Exposed to sound.

far field

The zone where, to an observer, sound originating from an array of sources (or a spatially distributed source) appears to radiate from a single point.

Fourier transform, Fourier synthesis

A mathematical technique which, although it has varied applications, is referenced in a physical data acquisition context as a method used in the process of deriving a spectrum estimate from time-series data (or the reverse process, termed the inverse Fourier transform). A computationally efficient numerical algorithm for computing the Fourier transform is known as the fast Fourier transform (FFT).

frequency

The rate of oscillation of a periodic function measured in cycles per unit time. The reciprocal of the period. Unit: hertz (Hz). Symbol: f. 1 Hz is equal to 1 cycle per second.

frequency weighting

The process of applying a frequency-weighting function.

frequency-weighting function

The squared magnitude of the sound pressure transfer function (ISO 18405:2017). For sound of a given frequency, the frequency-weighting function is the ratio of output power to input power of a specified filter, sometimes expressed in decibels. Examples include the following:

  • Auditory frequency-weighting function: compensatory frequency-weighting function accounting for a species’ (or functional hearing group’s) frequency-specific hearing sensitivity.
  • System frequency-weighting function: frequency-weighting function describing the sensitivity of an acoustic recording system, which typically consists of a hydrophone, one or more amplifiers, and an analogue-to-digital converter.

functional hearing group

Category of animal species when classified according to their hearing sensitivity, hearing anatomy, and susceptibility to sound. For marine mammals, initial groupings were proposed by Southall et al. (2007), and revised groupings are developed as new research/data becomes available. Revised groupings proposed by Southall et al. (2019) include low-frequency cetaceans, high-frequency cetaceans, very high-frequency cetaceans, phocid carnivores in water, other carnivores in water, and sirenians. See auditory frequency-weighting functions, which are often applied to these groups. Example hearing groups for fish include species for which the swim bladder is involved in hearing, species for which the swim bladder is not involved in hearing, and species without a swim bladder (Popper et al. 2014).

geoacoustic

Relating to the acoustic properties of the seabed.

harmonic

A sinusoidal sound component that has a frequency that is an integer multiple of the frequency of a sound to which it is related. For a sound with a fundamental frequency of f, the harmonics have frequencies of 2f, 3f, 4f, etc.

hertz (Hz)

Unit of frequency defined as one cycle per second. Often expressed in multiples such as kilohertz (1 kHz = 1000 Hz).

hydrophone

An underwater sound pressure transducer. A passive electronic device for recording or listening to underwater sound.

impulsive sound

Qualitative term meaning sounds that are typically transient, brief (less than 1 s), broadband, with rapid rise time and rapid decay. They can occur in repetition or as a single event. Sources of impulsive sound include, among others, explosives, seismic airguns, and impact pile drivers.

isopleth

A line drawn on a map through all points having the same value of some specified quantity (e.g., sound pressure level isopleth).

level

A measure of a quantity expressed as the logarithm of the ratio of the quantity to a specified reference value of that quantity. For example, a value of sound pressure level with reference to 1 μPa2 can be written in the form x dB re 1 μPa2.

monopole source level (MSL)

A source level that has been calculated using an acoustic model that accounts for the effect of the sea-surface and seabed on sound propagation, assuming a point source (monopole). Often used to quantify source levels of vessels or industrial operations from measurements. See also radiated noise level.

octave

The interval between a sound and another sound with double or half the frequency. For example, one octave above 200 Hz is 400 Hz, and one octave below 200 Hz is 100 Hz.

parabolic equation method

A computationally efficient solution to the acoustic wave equation that is used to model propagation loss. The parabolic equation approximation omits effects of backscattered sound (which are negligible for most ocean-acoustic propagation problems), simplifying the computation of propagation loss.

peak sound pressure level (PK), zero-to-peak sound pressure level

The level (Lpk) of the squared maximum magnitude of the sound pressure (p2pk) in a stated frequency band and time window. Defined as Lpk = 10log10(p2pk/p20). Unit: decibel (dB). Reference value (p20) for sound in water: 1 μPa2.

peak-to-peak sound pressure

The difference between the maximum and minimum sound pressure over a specified frequency band and time window. Unit: pascal (Pa).

permanent threshold shift (PTS)

An irreversible loss of hearing sensitivity caused by excessive noise exposure. Considered auditory injury. Compare with temporary threshold shift.

point source

A source that radiates sound as if from a single point.

propagation loss (PL)

Difference between a source level (SL) and the level at a specified location, PL(x) = SL − L(x). Unit: decibel (dB). See also transmission loss.

radiated noise level (RNL)

A source level that has been calculated assuming sound pressure decays geometrically with distance from the source, with no influence of the sea-surface or seabed. Often used to quantify source levels of vessels or industrial operations from measurements. See also monopole source level.

received level

The level of a given field variable measured (or that would be measured) at a given location.

reference value

Standard value of a quantity used for calculating underwater sound level. The reference value depends on the quantity for which the level is being calculated:

Quantity Reference value
Sound pressure p02 = 1 µPa2 or p0= 1 µPa
Sound exposure E0= 1 µPa2 s
Sound particle displacement δ02 = 1 pm2
Sound particle velocity u02 = 1 nm2/s2
Sound particle acceleration a02 = 1 µm2/s4

shear wave

A mechanical vibration wave in which the direction of particle motion is perpendicular to the direction of propagation. Also called a secondary wave or S-wave. Shear waves propagate only in solid media, such as sediments or rock. Shear waves in the seabed can be converted to compressional waves in water at the water-seabed interface.

sound

A time-varying disturbance in the pressure, stress, or material displacement of a medium propagated by local compression and expansion of the medium. In common meaning, a form of energy that propagates through media (e.g., water, air, ground) as pressure waves.

sound exposure

Time integral of squared sound pressure over a stated time interval in a stated frequency band. The time interval can be a specified time duration (e.g., 24 h) or from start to end of a specified event (e.g., a pile strike, an airgun pulse, a construction operation). Unit: pascal squared second (Pa2 s). Symbol: E.

sound exposure level (SEL)

The level (LE) of the sound exposure (E) in a stated frequency band and time window: LE = 10log10(E/E0) (ISO18405:2017). Unit: decibel (dB). Reference value (E0) for sound in water: 1 µPa2 s.

sound field

Region containing sound waves.

sound intensity

Product of the sound pressure and the sound particle velocity (ISO18405:2017). The magnitude of the sound intensity is the sound energy flowing through a unit area perpendicular to the direction of propagation per unit time. Unit: watt per metre squared (W/m2). Symbol: I.

sound particle velocity

The velocity of a particle in a material moving back and forth in the direction of the pressure wave. Unit: meter per second (m/s). Symbol: u.

sound pressure

The contribution to total pressure caused by the action of sound (ISO18405:2017). Unit: pascal (Pa). Symbol: p.

sound pressure level (SPL), rms sound pressure level

The level (Lp) of the time-mean-square sound pressure (p2rms) in a stated frequency band and time window: Lp = 10log10( p2rms/p20) = 20log10(prms/p0), where rms is the abbreviation for root-mean-square. Unit: decibel (dB). Reference value (p20) for sound in water: 1 μPa2. SPL can also be expressed in terms of the root-mean-square (rms) with a reference value of p0 = 1 µPa. The two definitions are equivalent.

sound speed profile (SSP)

The speed of sound in the water column as a function of depth below the water surface.

source level (SL)

A property of a sound source equal to the sound pressure level measured in the far field plus the propagation loss from the acoustic centre of the source to the receiver position. Unit: decibel (dB). Reference value: 1 μPa2 m2.

temporary threshold shift (TTS)

Reversible loss of hearing sensitivity caused by noise exposure. Compare with permanent threshold shift.

transmission loss (TL)

The difference between a specified level at one location and that at a different location: TL(x1,x2) = L(x1) − L(x2) (ISO 18405:2017). Unit: decibel (dB). See also propagation loss.

unweighted

Term indicating that no frequency-weighting function is applied.

wavelength

Distance over which a wave completes one cycle of oscillation. Unit: metre (m). Symbol: λ.

Contact

Email: ScotMER@gov.scot

Back to top